top of page
Gentle Conveyor System
Cablevey Conveyors
Enclosed Conveyor System with Disc and Tube Cable Conveyors from Cablevey
Gentle Conveying
Minimises Product Breakage
Easy to Clean
Compatible with CIP (Clean In Place) System
Ensure the transportation system integrates seamlessly with the building, offering flexibility for multiple loading and unloading points for materials or products.
Conveying Mixed Raw Materials and Products Without Layer Separation
Easy Maintenance
Time-Saving
Dust-free and protected from external contamination through closed-pipe conveyor systems.
Operates with low-horsepower motors, ensuring energy efficiency and quiet performance.
7
5
6
3
4
8
2
9
1
component
1
1 : Drive unit
The cable is pulled through the drive unit by an electric gear motor
mounted to a stainless steel frame. The cable can enter and exit through
either tube port as required for your layout.
2
2 : FUNNEL
Funnels are used to discharge material from rotary discharges and/or cleanouts.
Funnel outlets are available in a wide variety of sizes and connection types to fit your needs.
3
3 : INSPECTION SECTION
The Inspection Section is a food grade plastic tube that
allows you to see the product conveyed and observe the cleaning process.
These sections can be installed in the vertical or horizontal runs as desired
4
4 : SWEEP
Sweeps change travel to any desired direction. Sweeps are available in many
angles from 0-90 degrees and in several different
radius dimensions (45, 60, & 90 degrees) to fit restricted spaces.
5
5 : COMPRESSION COUPLER
The coupler’s food grade rubber gasket ensures
a good seal against air, water and dust. The coupler holds the tubes
together in perfect alignment to provide the discs a smooth path.
6
6 : INLET
Inlets are available in a wide variety of lengths to accommodate various needs.
The sides of the inlets are available in different slopes to accommodate
different material flow properties. Multiple inlets may be used if desired.
7
7 : TURNAROUND
The turnaround contains a sprocket that facilitates reversing
cable direction from the return side of the system to the product conveying side.
The sprocket is mounted on a mechanism designed to provide proper cable tension.
8
8 : DISCHARGE
The discharge has the ability to be open or closed allowing
materials either to pass through or exit the conveyor at that point.
9
9 : BRUSH BOXA Brush Box
is a housing that the cable and discs pass through.
The Brush Box contains two roller brushes mounted above and below the cable and discs.
As the cable moves through the discs turn the brushes removing any clinging
particles into a waste chute for disposal. This mechanical process
operates without additional power requirements.
bottom of page